Quote from: leo48 on May 04, 2011, 06:30:14 AM
The plastic tube has large amounts of carbon C₁₂
Leo48

Leo, wouldn't the carbon need to be conductive like the carbon in the Gray tube to undergo a transmute? Crossed layers of carbon fiber were used to produce a negative resistor a few years ago.

I have read some of the same stuff DimaWari has regarding the magnets and conditioning at a Russian forum. I don't know.

One thing I do know is that the SR device, if even real, and that is doubtful, seems totally different than Kapanadze. So far, the only "replication" turned out to be a fake produced by delamorto. That speaks volumes in itself.

I have built most parts of the SR device and it did not work.

@ above,

The only repeating pattern in this kapanadze OU story that we are forced to accept  (as reasonable men) that there is no reason to believe that anyone has ever managed to pulled out any working replication. Reasonable / clever man have also many doubts regarding Kapanadze device functionality itself.

But no matter what, people will wander and search through rumors and blurry images, gossips, fake devices, pictures with enigmatic eyebrows  etc until Kapanadze himself admits this has been a staged device. but again a new device will succeed this....

Until then, go go go to page 500!

Why? Replication of Kapanadze device is possible,like he replicated Tesla device 

@FittySense

In your SR/Cosmo setup did you use two HV source? One Hv is connected to the coil inside the ferrite and other was connected to spark gap and coil outside?

Quote from: DimaWari on May 04, 2011, 11:17:54 PM
@FittySense

In your SR/Cosmo setup did you use two HV source? One Hv is connected to the coil inside the ferrite and other was connected to spark gap and coil outside?

I did use a HV source (20 KV AC at 10 KHZ ) running through the coil outside. I did not have a coil inside but tried a bunch of 1 turn type stuff there running the ground through the center.

I ordered some HV diodes and will take a stab with a unipolar DC pulse on the HV. they should be here in about a week or so.

I used the original SR schematic for coil winding since that had the broken symmetry between the coil and ground.

What can you tell me about the inside coil? I would not say I have given up but merely have proven that the SR schematic is junk and has nothing to do with Kapanadze directly.