@all,

let's see what Mr Durban has to say before we go wild again with theories.   There will be plenty of time to incorporate any new information into our theories/experiments.

EM

Erfinder, sorry but if Tesla knew how to produce electricity from thin air, he would have never invented something to admit electricity in the air nor would he have invented a way to attract and utilize the electricity he had emitted in the air. Tesla's TPU device was invented 13 years before his inventions of admitting electricity and attracting electricity from the air.

Tesla wasn't an idiot and to say he invented a way to receive electricity from the air by using a TPU that was mobile and then 13 years later invented one that had to be stationary and didn't put out near as much power, would be the same as saying he was an idiot.

Think about it and really try to understand his patent of a TPU device as well as what it was intended for.

What is fascinating is the amount of  interest shown here as opposed to the interest in the thread that Spherics started...
I hope that some of you see the difference and relevance ..
I guess a good story has more value than actual experiments

Here are two of perhaps the best vids on youtube that demonstrate the use of this power. In the water heater  video this is keely stuff and demonstrates that you only need an extremely low power source of the correct frequencies to create massive amounts of power.

http://www.youtube.com/watch?v=06iCfowinUM

Like the TPU the geometry and the frequencies are vital to correct operation a tiny PP3 is all that is required.  Likewise Joseph Newman is a bit of a nutter but he also shows you only need voltage to create an abundance of power.

in this next video this generator is collector and amplifier the back EMF to produce an abundance of power. Notice how the lead from the lamp fitting takes output power and feeds it back to the input motor. The plausibility of the video is backed up further by the drop in power when he switches from mains to self running mode.

http://www.youtube.com/watch?v=JYmrQ8q0F98&feature=related

bolt, sorry but those two videos are not all they are said to be nor should anyone think of them to be anything more then just attempts to fraudulently get people to invest in their ideas.

What the videos real close. the first one is never activated and if it was, it was done before the footage was recorded. He was asked to start it and all he did was hooked a probe in the voltage tester.

The second video shows the tops of the coils on the device and I for one know that this can not produce more energy then it consumes. He must be using capacitors as well as the back EMF to make it run and then it will only run as long as the power is supplied.

I have noticed that a lot of people are using the back EMF's as a way to try and fool people because of it's advantage it has in preserving the current not used. It maybe very efficient which would allow it to run for a long time on very little amperage. I would go in to more detail but I can't at this time because of a project I am working on with a pulse motor design.
Refer to his motor and that of a bedini pulse motor and you get the same results.