Kapanadze Cousin - DALLY FREE ENERGY

[conico]

A scope probe on grenade and the second probe on capacitor in series with inductor.
from 8 Khz to 14.8 Khz signals are in faze
from 15Khz to45Khz signals are opposite, choose a frequency from this part were signals are opposite

[NickZ]

   conico:   The TL494 circuit does not go lower than 13.5KHz, nor does it need to go lower than that. I followed the Ruslan/Stalkers induction circuit diagrams, that I have previously posted.  But, I've seen no inversion, or frequency change by adjusting the duty cycle. My frequency is steady unless I change it on the TL494 board.

[conico]

NickZ, i use 1.5nF for base time of TL494 and now my push-pull start from 8 Khz to 66 Khz
A scope probe on grenade and the second probe on inductor different frequency, on inductor  two times, three times  four times the grenade frequency. I used the duty cycle pot from push-pull.
May be you don't have a scope probe on inductor !!! you have the scope probe on Wima cap?

[Sergh]

Grenade coil is not in series with 28 turns
https://overunity.com/12736/kapanadze-cousin-dally-free-energy/dlattach/attach/172564/

Such high accuracy of frequency  can be obtained only  from cesium clocks:
https://en.wikipedia.org/wiki/Atomic_clock
Recently worked a little with them.

[conico]

They use on-line calculator which give  high frequency accuracy like this http://www.pronine.ca/lcf.htm

the result of that on line calculator is multiplied by a coefficient of 0.7 or 0.8 for practice