Kapanadze Cousin - DALLY FREE ENERGY

[electronpulsemaster]

where can I download the pictures,report and schematic Wesley got from this guy?

[NickZ]

   As I'm trying to understand the working principal of the first or second of the Akula devices, I've gone back to where some of us started a while back, to back engineer his device.
The red letters are Akula's explanations (in the link below), of his ideas and tips, that he used in designing his first device:
http://www.overunity.com/12736/kapanadze-cousin-dally-free-energy/1905/#.U7m6pkCjIUc

  Here is Igor Moroz's latest video, always doing something new and different, in his efforts towards a self runner, or what he calls regenerative energy recuperation.
  Yet, I don't see how any circuit that is running a load of bulbs, is "regenerative" or recuperating energy. As power is being drawn out by the bulbs. And, the consumed power drawn by the bulbs and circuit must be replaced back, from somewhere. Therefore, if there's any regeneration of energy, there must be some other source of input, besides the original input source, that is being drawn in, to replace the consumed energy. Or not?
https://www.youtube.com/watch?v=IpAuvTBCugs
 

[Utopia Now]

I am trying to understand it all

I am reading the Vladimir Utkin pdf again and more and more pieces of the puzzle come into place
  http://www.free-energy-info.com/VladimirUtkin.pdf

Prezi doc :  DonZ Device
  http://prezi.com/fiwgtl78it85/donz-device/     This doc takes some time to load on your PC  but than you can zoom in and out and click on some links .

If you want to download it  to save the Prezi doc.  you can use this link
  http://prezi.com/recommend/vwzwag678bmv/

All help and Tips are Welcome  ... I appreciate everybody`s inspiration .

Thank you All

Utopia Now

[NickZ]

  After viewing the blue Kapanadze coil picture taken from  the aquarium video, I would assume that if one wants an output voltage of 110v, instead of the 220v, one must use less coil wire turns than is shown in the picture above.
  So, that instead on 48,48, 24,24, and 12, 12 turns, there should be something like 48, 24, and 12, or so turns, to make a 110v output coil circuit. I don't know if Akula was or is still using the same amount of turns as shown in the blue Kapanadze coil, or not.
  Any advice on this would be welcome. As I'm thinking of winding such a coil to use on my Mazilli/yoke crt.

[zcsaba77]

hi for all

my opinion is this system good nothing to do disassebly it (if work)! forth and back, smaller forth and back and again smaller forth and back, need for amlifycation, maybe is possible make half like this : 24+24+12+12+6+6 but will change frequency, now is question what is easier make same like original and put step down transformer or make new type device for 110VAC!?

regards zcsaba77