All Permanent Magnet Motor

[magnetman12003]

Tom states he's unsure of the carriage bolt material, but he also states it sticks to the block magnet. I believe they are low grade magnetic stainless steel.

Lowering the top with 4 bolts attached to within 1/2" of the two coupled ring magnets beneath would cause the four large magnetic carriage bolts to stick fast to the rings. There is no way anything on that setup could ever spin!

Tom's first design did not share that outstanding "Lock Up" feature. 79 years is enough time to produce a loose screw.

The bolts did not stick fast to the large ring magnet but spun with a finger touch without the tumbler in place and the bolts are angled and touching the 45 degree magnet (All done with fingers) All needed now are my tumblers.
Tom

[conradelektro]

I rather should not, but I decided to give a little hint and an inconclusive photo of my antigravity desk. If you enter my study you will see a desk with feet, but the feet float 2 millimeters (5/64 inches) above the floor. One can only see that by sliding a sheet of paper between the floor and the bottom of a foot. In this way the invention is well hidden from prying eyes.

I suspect that magnetman12003's permanent magnet motor is in fact an antigravity contraption and he hides it as a motor. A clever ploy.

I always advice to not speak about an invention in an open forum (to be able to patent and sell it later on). But magnetman12003 and me, we both could not resist the temptation to brag a bit about our invention (as so many in this forum). Of course the essential details are not shown, they will be in the patent.

Greetings, Conrad

[synchro1]

"Of course the essential details are not shown".[/size]

[/size]
Perhaps to conceal a hidden power source! Magnetman12003 has demonstrated a few very powerful magnet spinners. Placing one out of sight can produce remote effects.[/size]

[synchro1]

                                       "Of course the essential details are not shown".


Perhaps to conceal a hidden power source? Magnetman12003 has demonstrated a few very powerful magnet spinners. Placing one out of sight could easily produce "Poltergeist" effects from a distance. The erect magnetic bolts would serve as sails for the flux vortex.

[conradelektro]

                                       "Of course the essential details are not shown".
Perhaps to conceal a hidden power source? Magnetman12003 has demonstrated a few very powerful magnet spinners. Placing one out of sight could easily produce "Poltergeist" effects from a distance. The erect magnetic bolts would serve as sails for the flux vortex.

Are Poltergeist and flux vortex really a better explanation than antigravity? What about ether radiation or zero point energy, much better is a Tesla charge from a bifilar pancake coil?

I think there is a bifilar pancake coil (à la Tesla) hidden in the wooden disk of the magnetman12003 invention and the "high tension which is converted into energy stored between the bifilar windings" causes anti gravity. If you look carefully at the short video published bei Tom you can see the light distortion which always comes hand in hand with anti gravity. I see this peculiar and telling light distortion also around my anti gravity desk, but it is hard to capture on video. (Therefore no video!)

Guess where the pancake coil is hidden in my anti gravity desk (hint: what is big, horizontal, rather thin and flat on a desk)?

Greetings, Conrad