Is this the first selfrunning overunity motor w/o batteries ? Mike?s motor

[Peterae]

Darren
I think what you mean by Quad-filar is basicaly 3 28 gauage strands and 1 30 gauage strand all together then series the L2 coil, now that is interesting because it would mean that ineffect i have created L2 how Tesla suggested for his Special Bifliar winding

[Peterae]

I say im going to wind tommorow, i only get mondays off work, i ordered the dam wire friday, and am praying it will arrive tommorow or it will be another week

[helmut]

Hello All

The Question about the bifilar winding causes many more Questions.

But it might be helpfull to read the Books about this matter.

therevor i post a drawing
Helmut

Sorry for the bad pic    i try to make it better

[z_p_e]

Darren
I think what you mean by Quad-filar is basicaly 3 28 gauage strands and 1 30 gauage strand all together then series the L2 coil, now that is interesting because it would mean that ineffect i have created L2 how Tesla suggested for his Special Bifliar winding

Hi Peter.

Yes that's exactly what I mean. 4 wires quad-filar, two of which (L2a and L2b in series) make up L2 if one wishes to do it this way.

I believe there are advantages to making L2 this way. Did Mike make his this way? One would think that he would have mentioned something about this odd detail, but he did not.

Regards,
Darren

Good luck with your winding, and perhaps you could do me a huge favor after they are wound.....measure the inductance and resistance of each. I'd like to compare that to my calculated values. Thanks, it would be much appreciated.

[Peterae]

Hi Darren
I havent got an inductance meter, but i can measure the resistance, unless you no off an easy way to measure inductance.I'm still praying for the post man.
now when i wind the sides that go either side of the axial do i do half the turns one side and the rest of the turns the other side, or alternate left side 1 coil right side 1 coil ect.
I would think 120 left side of axal then 120 right side, of course the top and bottom will be side by side anyway, its just for the parting clearance for the shaft to turn.

Peter