Pulsed DC Transformer with Embedded Magnets

[Hope]

Update on the 3 dollar laser test probe.  The photo sensor to pick up the reflected beam is under a dollar at radio shack.  Connect it to your microphone input on your sound card and use something like the free Virtual Analyser software.   This lite radar probe will not de tune your circuits and is very quik to build.   I think by sampling the ambient light first we can then filter it out of the final readings if it gets "noisy". URL http://lifehacker.com/292718/build-a-laser-spy-microphone-on-the-cheap     

edited

[Hope]

Can you keep resonance if you only pick the spike off the 3rd the 6th and the 9th phases and reinput them? (don't do it constantly until you are ready).  Also inputting a know frequency into a scope and mixing them with the unknown frequency will give you a picture very different that a normal sign wave.  Can we figure out what that wave form show look like and work backwards?

[The Observer]

Tseung,

What I did was use a signal generator that pulsed a 1 Volt Square Wave.
Then I turned up the frequency until the it matched the ring of the Transformer.

What is happening is that the Transformer is literally ringing like a bell... at this specific Frequency.

Step 1 as you have suggested is to find the Resonant Frequency of the Transformer in Question.
                                           (The smaller the transformer the higher the frequency)
Step 2 ( I would think) would be constructing a Resonant Circuit that matches that Frequency in the Secondary.

Hope all is well.. Keep up the good work LT.

Best Regards,
                        The Observer

[ltseung888]

Tseung,

What I did was use a signal generator that pulsed a 1 Volt Square Wave.
Then I turned up the frequency until the it matched the ring of the Transformer.

What is happening is that the Transformer is literally ringing like a bell... at this specific Frequency.

Step 1 as you have suggested is to find the Resonant Frequency of the Transformer in Question.
                                           (The smaller the transformer the higher the frequency)
Step 2 ( I would think) would be constructing a Resonant Circuit that matches that Frequency in the Secondary.

Hope all is well.. Keep up the good work LT.

Best Regards,
                        The Observer

Thank you, Observer.  In your case, sound (the ring) was actually involved.  The appearance of sine wave was normal and expected.  Much energy will be changed into sound energy.  I am looking for the resonance conditions such as Stan Meyer, Gadgetmail etc. that can change the energy into heat or generate HHO gas.

[XS-NRG]

I am looking for the resonance conditions

You don't even know what that is or what it looks like HAHAHA.