forest,

Just grab a soldering iron for once in your life and stop theorizing DUDE.

  I'm trying to help......

http://www.overunity.com/index.php?topic=6123.msg238894#msg238894

bart wow DUDE, do you have diamond wow balls ? because wow iron ones would be to wow soft if you post wow working device...  wow I would like to see it wow
and this -> <- guy too 

                                                    Ouch!!

                              Some of the blind guys are fighting!

                                                       
                                                       
                                                       

I think everyone contributes in their own ways. And each has their own values as to what is worth what.
Im getting the stuff put together for the igniter pulse motor project. I had a lot to sort through after the move.

Im also going to post a new thread on a magnet motor idea I have worked on for a while but had to stop and take a breather. I did a build that had a critical flaw in timing that I will disclose with pics and vids of the concept. My motto at Fizzx was " I always think of it like an electric motor, ya gotta have pole switching." And this idea is to the point.

Ok  im digging out things I need. I may get the other thread going in a bit just to throw some meat on that table.

Mags

Ok I got my motor setup and just getting some things in place to make a few runs.
The other thread on my mag motor is another thing that needs to get going. But I want to get this buzzing first.
The plan is to use a large inductor to charge a cap and then discharge it into the pulse motor as a load.
Will be interesting to see it go.  I yike motors.   

I will set it up so the big motor coils can be put in series or parallel or even single combinations to get the best run going. Im going to use a reed to operate a relay for the contactor. 40A relay.

Mags