Kapanadze Cousin - DALLY FREE ENERGY

[apecore]

Missing that Dally device was fake from day one perhaps? Why should one dismantle his working OU device three days after presentation without taking any measurements and never show something like it again?

Yes thats strange,  but before we start again the "fake" discussion.

But do we have a theory about how the system should must work?
And can we figure out why Itsu don´t get big nano spikes in his grenade-inductor coil?
Do we get different results with karcher systems and is this explainable in Itsu's situation

Is it possible to put those two systems next to each other and figure out the aspects as mentioned above?

I' m asking this because it would be frustated if someone starts again building from scrap, without getting the current nowledge about the issue's we run into.
I think Itsu is getting right on track also in the way he presents his setup and results.

Greetings

[verpies]

But do we have a theory about how the system should must work?

There are two competing theories:
1) Energy from Aether obtained by shaking it.
2) Energy from matter by alignment and resonance of its nuclei.

I do not understand the first one so I cannot even advise him how to meet all the necessary conditions to obtain it.
I understand the second one, and according to that understanding he is missing three factors necessary to obtain it.

[verpies]

I used a range of fixed series resistors from 5, 12, 22, 32, 51, 68, 100 Ohm with the collector voltage on 130V.

This is not what I expected to see.  Most likely the probe position is wrong.

[verpies]

And can we figure out why Itsu don´t get big nano spikes in his grenade-inductor coil?

Perhaps because his little nano spikes are not supposed to be just transferred efficiently to the LC circuit, but are supposed to cause different and larger nano spikes elswhere, some microseconds later ...but they don't because other conditions are not met.

The coiled coax forms a bifilar self-cancelling winding which is not the best winding for efficient coupling of these nanospikes by induction.  I am surprised that they "leak out" of the coax at all.

Do we get different results with karcher systems and is this explainable in Itsu's situation

The results are hard to compare due to the lack of proper measurements but I do see a commonality between the "Kacher" and the nanopulser - namely they both generate dense spectra of wide range of frequencies.  Dense spectrum is an essential requirement for the Modus Operandi #2.

Is it possible to put those two systems next to each other and figure out the aspects as mentioned above?

Yes, but only if you have willing owners of two of such working systems. AFAIK these people are not very cooperative.

[verpies]

I synced the nano-pulser to the Push pull driver (TL494) instead of the FG.
I will see if shifting the pulse compared to the sine wave (± 90°) has any effect.

How did you synch it?
Is the phase shift between the sinewave and the nanopulse, smoothly adjustable between 0º and 90º in your circuit ?