Working Magnetic Motor on you tube??

[dean_mcgowan]

Damn it we have been scammed again .. Gullible bunch aren't we .. bugger !!

[jcims]

Al seems to have disappeared from the steorn forums, so no info from the source right now!

He checked in yesterday and today... Steorn forum search

[geodan]

Al seems to have disappeared from the steorn forums, so no info from the source right now!

He checked in yesterday and today... Steorn forum search

There was a post from Al today, and it was re posted here by Jag a page back or so...

[RunningBare]

alsetalokins last visit to the steorn forum was 13 hours ago.

[Jdo300]

@Crashuni1
Here's another Drawing of the Rotor Jason did an excellent job, but i alway work up my own so I can do amendments if needed.

Thanks Jason
Bill

I guess that is yet another way to interpret the 2.5" spacing of the rotor mags, you take it to mean 2.5" to one of the corners of the octagon, not the flat face.

Ok Ken & Group
What's the OD of the Rotor 2.875" or 3.0" ?
If measured other than other than what i show there is only 0.0440" of material left.

Bill

I think there is confusion here, I have seen 2.5" from the corner of the octagon in your drawing (which to me actually looks closer to the photographs), I have seen 2.5" to the center of the rotor magnet (the midle of the channel), and then on steorn someone thinks it should be 2.5" to the inside flat face of the octagon.

The poster that thinks it is 2.5" to the flat face of the octagon, also thinks the radius of the rotor should be 3" rather than 2.875".

When I look at the photos, the magnet channel (which is 0.25") looks about the same thickness as the thickest part of the material left on the outside of the rotor (the crescent shaped pieces), but it would be easy to miss a 1/16th difference in the photos.

It is hard to say, may have to study the photos closely.

Al seems to have disappeared from the steorn forums, so no info from the source right now!

OK, once again for those who missed my post regarding the rotor dimension issue. I have already addressed it here in the following post:

http://www.overunity.com/index.php/topic,3871.msg70719.html#msg70719

In short, the OD of the rotor should be 2.875 in and the distance from the center of the disk to the inner edge of the octagon is 2.375 in. These dimensions are clearly marked in the blueprints I published.

EDIT: I meant OD of 5.75 inches

God Bless,
Jason O